Guides · 2 min read

How to Tell the Drill from the Impact Wrench in a DODOWIN TC2 Kit

A quick guide to telling the keyless drill chuck from the socket drive before you start a project.

DODOWIN TC2 kit photo showing the cordless drill and impact wrench side by side

Quick answer

On the DODOWIN TC2, the drill has a round keyless chuck with jaws for a drill bit. The impact wrench has a drive at the nose for a matching impact socket. For a pilot hole, start with the drill. If the job calls for a socket on a nut or bolt, check whether the wrench and socket are appropriate for that fastener.

1. Look at the nose of each tool

With both batteries removed, put the tools side by side. Find the jaws inside the drill’s round chuck. Behind the chuck, look for the adjustment collar, another visual clue on the TC2 drill. The impact wrench has a projecting square drive in the kit image. A socket fits over that drive; there are no chuck jaws holding a round drill bit.

DODOWIN TC2 drill detail showing the front chuck and adjustment collar

2. Check both ends of the accessory

Choose by job and by the fitting on the tool
Job Tool Before fitting the accessory
Make a pilot hole Drill Check that the bit suits the material and the shank fits the chuck.
Turn a nut or bolt that calls for a socket Impact wrench if the job allows it Check the drive size, the fastener fit and that the socket is impact rated.

The measurement at the back of a socket describes its fit on the tool. The measurement at the front describes its fit on the fastener. Check both independently. For fastening that requires a specified torque, follow the equipment maker’s instructions and use the specified torque tool for the final setting.

Common questions

Is the second TC2 tool an impact driver?

The TC2 listing identifies it as an impact wrench. A typical impact driver takes a hex-shank bit at the nose; an impact wrench uses a socket drive. See DEWALT’s explanation of the two fittings for the general distinction.

Where can I verify what the TC2 kit includes?

Review the TC2 drill and impact wrench kit listing for the package, and check the markings and instructions supplied with your tools for exact accessory sizes. Remove the battery before fitting or changing any bit or socket.

Related guide: choosing between one-battery and two-battery tool kits.